What To Do If - Leonard LV1515 Benutzerinformation

1. To unlock the filter system, turn the
handle on the microfilter (B) approxi-
mately 1/4 counterclockwise.
2. Remove the filter system.
3. Hold the coarse filter (A) by the handle
with the hole.
4. Remove the coarse filter (A) from the
microfilter (B).
5. Remove the flat filter (C) from the bot-
tom of the appliance.

WHAT TO DO IF...

The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
• The programme indicator flashes continuously.
• The end indicator flashes one time intermittently.
• The programme indicator flashes continuously.
• The end indicator flashes two times intermittently.
• The programme indicator flashes continuously.
• The end indicator flashes three times intermittently.
Warning! Deactivate the appliance
before you do the checks.
D
Alarm code
6. Clean the filters below running water.
7. Put the flat filter (C) to its initial position.
Make sure that it assembles correctly
under the two guides (D).
8. Put the coarse filter (A) in the microfilter
(B) and push the filters together.
9. Put the filter system in position.
10. To lock the filter system, turn the han-
dle on the microfilter (B) clockwise until
it locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
With some malfunctions the indicators
flash to show an alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
leonard 29
Malfunction