Sony LH71A Bedienungsanleitung Seite 100

4. Installation and Connection of Unit
Connections when using the addition function with lathe function
Screw down firmly.
To the first axis
Clamp the cable to prevent the
*1
To the
connector from pulling out.
second or
Provide slack as shown to
third axes
ensure that force is not being
applied to the connector.
*1
Measuring unit
Z -axis
2
X-axis
n n n n n
Connect the supplied ground wire to ensure that the counter
unit is the same potential as the machine proper.
*1 If the resolutions of the measuring units performing the addition (Z
to connect the measuring unit with higher resolution to the second axis of the counter unit.
Example: Using measuring unit Z
Measuring unit Z
Measuring unit Z
4-4
(E)
First axis
Measuring unit input
DC output connector
To the second
or third axes
Ground
wire
Z -axis
1
PSC-21/22/23 AC adaptor (sold separately)
100 - 240 VAC± ± ± ± ± 10% 50/60 Hz
* Get power from lamp line.
X-axis
Z-axis
(resolution: 0.5 um) and measuring unit Z
1
(resolution: 0.5 um) : Connected to counter unit second axis
1
(resolution: 1 um)
2
2
3
Remote reset switch
Shielded cable
-axis, Z -axis) are different, be sure
1 2
(resolution: 1 um)
2
: Connected to counter unit third axis
Bracket
M4 x x x x x 16 anchor
bolts, 2 pcs.
(supplied)
LH71A / LH72