System Compatibility - Honeywell MILLER MIGHTEVAC Gebrauchsanweisung

3.0 SYSTEM COMPATIBILITY

The Miller mightevac Self-Retracting Lifeline is designed for use with Honeywell-approved com-
ponents only. Substitution or replacement with non-approved component combinations or sub-
systems or both may affect or interfere with the safe function of each other and endanger the
compatibility within the system. This incompatibility may affect the reliability and safety of the
total system.
3.1 PERSONAL FALL ARREST SYSTEM COMPONENTS
Three key components of the Personal Fall Arrest System (PFAS) need to be in place and properly
used to provide maximum worker protection.
ANCHORAGE/ANCHORAGE CONNECTOR
The first component is the anchorage/anchorage connector. The anchorage, also referred to as
the anchor point or tie-off point, is a secure point of attachment for connecting devices and must
be capable of supporting 5,000 lbs. (22.2kN) per worker. An anchorage connector, such as the
cross-arm strap, D-bolt or rebar hook anchor, is sometimes necessary to make a compatible con-
nection between the connecting device and the anchorage.
BODY WEAR
The second system component is the personal protective gear worn by the worker while perform-
ing the job. The only form of body wear acceptable for fall arrest is the full-body harness. Full-body
harnesses are engineered to aid in the arrest of a free fall and must be worn in all situations where
workers are exposed to a potential free fall.
CONNECTING DEVICE
The third component of the system is the connecting device, the critical link which joins the body
wear to the anchorage/anchorage connector. The most important feature of the connecting de-
vice is the built-in shock absorber. Whether the connecting device is a shock-absorbing lanyard or
self-retracting lifeline, they are designed to dramatically reduce fall arrest forces. Rope, web or wire
rope lanyards being used for fall arrest MUST be used in conjunction with a shock absorber (i.e.,
Honeywell Miller SofStop pack).
A
B
C
6