Network Status; Bd-Live Internet Connection; Initial Settings - Samsung HT-D5000WXZF Handbuch

Setup
Settings
Network Settings
Display
Select a network connection type.
Audio
Network
Wired
System
Wireless
Language (General)
Connect to the Wireless Router easily by pressing the
Security
WPS(PBC) WPS(PBC) button. Choose this if your Wireless Router
supports Push Button Confi guration(PBC).
General
One Foot
Connection
Support
2. Press the ENTER button.
3. Press the WPS(PBC) button on your router
within two minutes. Your product displays
the Network Selection Screen, and
automatically acquires all the network
settings values it needs and connects to your
network. When it is done, it displays an OK
button. Press the ENTER button on your
remote.
One Foot Connection
You can set up the wireless connection
automatically if you have a Samsung Wireless
Router which supports One Foot Connection. To
connect using the One Foot Connection function,
follow these steps:
1. Press the ▲▼ buttons to select One Foot
Connection.
Settings
Network Settings
Display
Select a network connection type.
Audio
Network
Wired
System
Wireless
Language
(General)
Connect to your wireless network automatically if your
Security
WPS(PBC)
Wireless Router supports One Foot Connection. Select
this connection type after placing the Wireless Router
General
One Foot
within 10 inches(25cm) of Samsung Wireless LAN Adapter.
Connection
Support
2. Press the ENTER button.
3. Place the Samsung Wireless Router within
25 cm (10 inches) of Samsung Wireless LAN
Adapter to connect.
4. Wait until the connection is automatically
established.
36
English
HT-D4500_ELS_1223.indd 36 HT-D4500_ELS_1223.indd 36
> Move " Enter ' Return
> Move " Enter ' Return

Network Status

Check whether a connection to the network and
the Internet have been established.
Settings
Network Status
Display
MAC Address
Audio IP Address
Subnet Mask
Network
KT_WLAN
Gateway
DNS Server
System
Internet is connected successfully.
Language
If you have a problem using any Internet services, contact your Internet service
provider.
Security
General
Support
Network Settings IP Settings
< Move " Enter ' Return

BD-LIVE Internet Connection

Set to allow or prohibit an Internet connection
when you use the BD-LIVE service.
•
Allow (All) : The Internet connection is allowed
for all BD-LIVE contents.
•
Allow (Valid Only) : The Internet connection is
allowed only for BD-LIVE contents containing a
valid certifi cate.
•
Prohibit : No Internet connection is allowed for
any BD-LIVE content.
✎
NOTE

What is a valid certifi cate?
When the product uses BD-LIVE to send the
disc data and a request to the server to certify
the disc, the server uses the transmitted data
to check if the disc is valid and sends the
certifi cate back to the product.

The Internet connection may be restricted
while you are using BD-LIVE contents.
System

Initial Settings

By using the Initial Settings function, you can set
the language, Network Settings, etc.
For more information about the Initial Settings
function, refer to the Initial Settings section of this
user manual. (See page 25)
XX:XX:XX:XX:XX:XX
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
Retry OK
2011-12-23 2011-12-23 3:59:10 3:59:10