Ironing Without Steam; Cleaning & Maintenance - Bosch Sensixx B20L Gebrauchsanleitung

• At the beginning of each use, it is possible that
drops of water will be dispensed alongside
steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
Tip : for better ironing results, iron the last
strokes without steam to dry the garment.
Cork HaNDlE IroN
(model dependent):
To get permanent steam, press the lock button
(16*) and slide it backwards until it locks. To
switch off the permanent steam, slide the lock
button forward.
important:
• The steam hose may get hot if you are ironing
for long periods.

ironing without steam

1. Begin ironing but without pressing the steam
release button.
C
Vertical steam
E
never direct the steam jet at garments
that are being worn.
never aim the steam at people or
animals.
1. Set the temperature control to the "•••" or "max"
position.
2. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing
the iron in a vertical position and pressing the
steam release button.
Cleaning &
Maintenance
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
3. If the soleplate is soiled with dirt or scale,
clean it with a damp cloth.
4. Never use abrasive products or solvents.
16
B OS C H
D
Storing the appliance
1. Always allow the appliance to cool down
before storing it.
2. Set the main power to the "0" position and
disconnect the mains cable.
3. Empty the water tank.
4. Place the iron on the iron pad, standing on the
soleplate.
5. Store the mains cable in the storage
compartment (5) and the steam hose in the
storage fixing (3). Do not wrap the cords too
tight.
6. Use the carrying handles (4) on the sides when
moving the appliance.
fabric protection
E
soleplate cover
(depending on the model)
The fabric-protection soleplate cover is used for
steam-ironing delicate garments at maximum
temperature without damaging them. Use of the
soleplate cover also does away with the need for
a cloth to prevent shine on dark materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place
the tip of the iron into the end of the soleplate
cover and pull the elastic strap over the lower
rear of the iron until it fits tightly. To release the
soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may be
purchased from the customer service or specialist
shops:
Accessory code
(After-sales)
00571510
F
Calc'n'Clean
Cleaning the Boiler
To extend the life of your steam generator and
to avoid any build up of scale, it is essential that
you rinse out the boiler after several hours of use
(approximately after 50 hours). If the water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check that the appliance is cold and
unplugged for more than 2 hours, and that the
water tank (1) is empty.
Name of accessory
(online shop)
TDZ2045