Ducati SBK749R 2005 Anleitung- Und Instandhaltungsheft Seite 116

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it open.
The EOBD warning light turns off after a pre-set time of 8
seconds.
2) Release the throttle as soon as the EOBD warning light
turns off.
3) The EOBD pilot light will flash. Now enter the electronic
release code shown on the CODE CARD given to the
customer at the time of consignment of the motorcycle by
the dealer.
4) Count a number of flashes of the EOBD light (8, fig. 4)
equivalent to the first number of the secret code.
Open full throttle and keep the position for 2 seconds, then
release. In this way the input of one figure is
acknowledged, EOBD pilot light comes on and stays on for
4 seconds. Repeat the operation until you have entered
the final digit.
If you fail to perform any operation with the throttle the
EOBD light will flash 20 times and then illuminate steadily
to inform you that the procedure must be repeated from
step 1.
5) When you release the throttle, if the code was inserted
in the correct way, you can have two situations, A or B:
A) the EOBD light starts flashing to indicate that engine
is enabled. The light switches off after 4 seconds,
or if engine speed exceeds the threshold value of
1000 rpm.
B) the CODE (12, fig. 4) light flashes until engine speed
exceeds 1000 rpm or until the vehicle is restarted.
6) Should the code NOT be entered correctly the EOBD
and CODE lights remain lit and the procedure can be
repeated starting from step 2 for as many times as
necessary.
Notes
Should the throttle twistgrip be released before the
set time, the warning light turns on again.
It is then necessary to bring the key to OFF and restart the
procedure from point (1).
E
23