Trevi HCX 10D6 DAB Bedienungsanleitung Seite 12

ENGLISH
REMOTE CONTROL
14
15
16
17
18
19
20
21
22
23
24
ACTIVATION AND REPLACEMENT OF REMOTE CONTROL BATTERY
SUPPLY
Connect the power cord (13) to 100-240V
Do not connect the appliance to electrical outlets other than those indicated.
At the first start-up the device will scan the DAB stations present, the display will show the word SCANNING. Wait until the display
shows the current time.
Note: Unless otherwise specified, the descriptions of the commands apply to both the device and the remote control.
ON/OFF
1. Press Main Power Switch (1) on the unit to put the unit in Stand-by mode (the time and date will be shown on the display);
2. To Enable/disable STAND-BY mode, press STANDBY button (14) on the remote control;
3. If you want to turn Off the unit completly, press Main Power Switch (1) on the unit.
Note: In CD, USB or AUX source, if no operation is performed within 10 minutes, the unit will automatically enter STANDBY mode.
12
DESCRIPTION OF CONTROLS
14. Standby button
15. FUNC button, source selection
16. RPT button
29
17. MUTE button, device sound exclusion
18. EQ button, selection of various preset sound modes
28
19. 
9
20.
21. MENU buttons
27
22. Key
23. INFO button
24. PROG button
26
25. VOL +/- buttons, volume adjustment
:
26.
27 F-/CH- button, previous folder in CD or USB mode/ preset
25 radio station
28. F+/CH+ button, next folder in CD or USB mode/ preset
radio station
29. ENTER key,
The remote control has a cell battery already installed. To activate the battery,
remove the transparent tab at the bottom of the remote control. The remote
control is now ready to use.
To Replace Battery:
1. Remove the battery compartment cover as per the illustration on the right.
2. Observe the correct polarity and install a 3V
3. Close the cover.
50/60Hz power outlet.
, Play/Pause/ confirm selection
button, previous track/ radio station
, Stop
button, next track/ radio station
HCX 10D6 DAB
lithium battery (CR2025).