Yamaha YZ250 Handbuch Seite 466

HANDLEBAR
11. Install:
9 Master cylinder 1
9 Master cylinder bracket 2
9 Bolt (master cylinder bracket) 3
NOTE:
9 Install the bracket so that the arrow mark a
faces upward.
9 First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the bolt
on the lower side.
12. Install:
9 Bolt (grip cap) 1
w
9 Install the grip cap so that the gaps
b b between the bolt (grip cap) and brake
lever 2 2 are equal. If you make a mistake in
the grip cap installation position, the brake
lever may contact the grip cap, resulting in
poor brake performance.
9 After tightening the bolts, check that the
throttle grip 3 3 moves smoothly. If it does
not, retighten the bolts for adjustment.
13. Install:
9 "ENGINE STOP" button 1
9 Clutch lever holder 2
9 Bolt (clutch lever holder) 3
9 Clamp 4
NOTE:
9 The "ENGINE STOP" button, clutch lever hold-
er and clamp should be installed according to
the dimensions shown.
9 Pass the "ENGINE STOP" button lead in the
middle of the clutch holder.
5-48
CHAS
9 Nm (0.9 m•kg, 6.5 ft•lb)
4 Nm (0.4 m•kg, 2.9 ft•lb)
a a and
4 Nm (0.4 m•kg, 2.9 ft•lb)