Yamaha YZ250 Handbuch Seite 196

REAR SHOCK ABSORBER SPRING PRELOAD
ADJUSTMENT
EC36M014
REAR SHOCK ABSORBER SPRING
PRELOAD ADJUSTMENT
1. Elevate the rear wheel by placing the suit-
able stand under the engine.
2. Remove:
9 Rear frame
3. Loosen:
9 Locknut 1
4. Adjust:
9 Spring preload
By turning the adjuster 2.
Stiffer ¡
Increase the spring preload.
(Turn the adjuster 2 2 in.)
Softer ¡
Decrease the spring pre-
load. (Turn the adjuster 2 2
out.)
Spring length (installed) a a :
Standard length
One I.D. mark
253 mm (9.96 in)
*252 mm (9.92 in)
Two I.D. marks
259 mm (10.20 in)
*258 mm (10.16 in)
Three I.D. marks
250.5 mm (9.86 in)
*249.5 mm (9.82 in)
*For EUROPE
NOTE:
9 Be sure to remove all dirt and mud from around
the locknut
adjustment.
9 The length of the spring (installed) changes 1.5
mm (0.06 in) per turn of the adjuster.
9The I.D. mark b is marked at the end of the
spring.
9The standard length and extent of adjustment
vary according to the quantity of I.D. marks.
cC
Never attempt to turn the adjuster beyond
the maximum or minimum setting.
3-30
INSP
ADJ
Extent of adjustment
245.5~263.5 mm
(9.67~10.37 in)
251.5~269.5 mm
(9.90~10.61 in)
243.0~261.0 mm
(9.57~10.28 in)
and adjuster before