Control Panel - Electrolux ERG47800 Benutzerinformation

• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
• Connect to potable water supply only.
Service
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

1 2 3 4
1. Pilot light
2. ON/OFF switch
3. Temperature regulator (warmest)
4. Temperature indicator
5. Temperature regulator (coldest)
6. Alarm light
7. Alarm reset switch
8. Action Freeze light
9. Action Freeze switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
The freezer is shut off by pressing the ON/
OFF switch until the Pilot light and the Tem-
perature indicator switched off.
Temperature regulation
The temperature can be adjusted between
-15°C and -24°C.
9) If a water connection is foreseen.
9)
Freezer Control panel
5 6 7 8 9
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
By pressing the Temperature regulators ,
the current temperature setting flashes on
the Temperature indicator. It is possible to
modify the setting temperature only with
flashed indicator. To set a warmer tempera-
ture, press warmest Temperature regula-
tor . To set a colder temperature, press
coldest Temperature regulator. The Tem-
perature indicator displays the newly selec-
ted temperature for a few seconds and
then shows again the inside compartment
temperature.
The newly selected-temperature must be
reached after 24 hours.
Caution! During the stability period by
the first starting the temperature
displayed can not correspond to the
setting temperature.
electrolux 21
are recyclable.