Changing The Source Device/Disconnecting; Turning The D Fine+ 2 Off; Aux Mode - Dockin D FINE+2 Bedienungsanleitung

CHANGING THE SOURCE DEVICE/DISCONNECTING

To select a new playback device while still paired, the current
Bluetooth® connection needs to be disengaged.
• Disconnect the current Bluetooth® connection on the source
device.
or
• Push and hold the button on your D FINE+ 2 for approx. 3
seconds.

TURNING THE D FINE+ 2 OFF

• Hold the button on the top of your D FINE+ 2 down for 3
seconds to switch the D FINE+ 2 off.
• The current charging status is visible via the battery LED for 15
seconds after turning the unit off.
CHARGING THE D FINE+ 2
Charge your D FINE + by using the provided power cable. The
charging input is located behind the cover on the back.
0 - 10% 11 - 30%
During charging the battery LED blinks in the corresponding color
to signal charging in progress. Once the device is completely
charged, the LED lights up permanently green.
14
> 30%
AUX-MODE
You can connect your D FINE+ 2 to a source device using the
provided AUX cable (3.5 mm plug cable).
The D FINE+ 2 power-saving mode is disengaged when the AUX
cable is connected. If the AUX cable and the mains adapter are
connected, this permits stationary use, for example as a PC speaker
or a TV soundbar.
1. Connect the source device to the AUX input of your D FINE+ 2
using the provided 3.5 mm plug cable.
2. Start playback on the source device.
15