Mounting Guidelines - Bresser 7002534 Bedienungsanleitung

8 Insert the other side of the pole to the square
hole of the plastic stand
NOTE:
Ensure the pole and stand's indicator align
9 Place the nut in the hexagon hole of the stand,
then insert the screw in other side and then
tighten it by the screw driver
10 Add rubber pads before mount on the pole
NOTE
Pole not included

MOUNTING GUIDELINES

- Secure the clamps (included) to a post or pole
- Install the sensor at least 1.5m off the ground for better and more accurate measurements.
- Choose an open area within 150 meters from the LCD display console
NOTE:
- After replacing the batteries of the wireless sensor or the unit fails to receive wireless sensor signal of a
specified channel, you need to press and hold [ SENSOR ] key on the console to pair this sensor again
- Avoid placing the transmitter in direct sunlight, rain or snow
- The building material and the position of the receiver and transmitter affect the effective range. So try
various locations to obtain the best result
- Place the units away from metal objects and electrical appliances to minimize the interference Position
the receiver and transmitter within the effective transmission range: 150m in usual circumstances.
SETUP THE CONSOLE
INSTALL THE BACKUP BATTERY
1 Remove the battery door of the console
2 Insert a new CR2032 battery as per the polarity information marked on the battery compartment
3 Replace the battery door
NOTE:
The backup battery can backup: Time & Date, Max/Min & Past 24 hours weather records, Alert setting
values, offset value of weather data and Sensor(s) channel history.
The built-in memory can backup: Router setting and Weather server setting
All manuals and user guides at all-guides.com
Step 8
Step 9
Step 10
8