Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting the
Cutting Speed
Thermo Fisher Scientific
•
The desired cutting speed is set continuously with the knob [C] and
is shown on display with values from 0–100.
Note!
To save time, the return travel speed is faster than the selected cutting speed.
In addition, the maximum cutting speed can be turned slower for fine
sectioning than for trim sectioning.
Switching over from trim sectioning to fine sectioning with knob [A]
results in a reduction of the motorized cutting speed according to the
corresponding pre-selection.
•
To pre-select the speed reduction, press the menu button [1].
•
In the sub-menu select „Autom. v-reduction" with the knob [A].
•
Turn the knob [A] to select the maximum speed from 0 up to 100.
•
Press the knob [A] again to store the selected speed.
•
Press the menu button [1] again to return to the normal display
mode.
c
!
aution
Switching over from fine sectioning to trim sectioning results in a corre-
sponding speed increase.
Operating Instructions
Display and Key Functions
Operation Manual HM335S
39
Werbung
Kapitel
Inhaltsverzeichnis
