BURG WÄCHTER BURGcam LIGHT 3010 Kurzanleitung Seite 52

If login failed, please check the WLAN signal strength and reset
the camera by holding down the reset key for 10 seconds to
return to factory settings before you repeating the setup.
A beep confirms successful transmission. You can do this by
tapping the yellow button under the QR code.
5 After successful setup, the device is displayed in the Device
list is displayed. Tap the device name to to access the
device-specific menu.
6 To remove, wipe to the left and start the erasing process.
confirm Remove BURGcam:
52 | English
(5) Tap on the device
name to change to
access the device-specific
menu.
(6) To remove, wipe to
the left and confirm the
deletion
Abb. 5 / 6
BURGcam LIGHT 3010