Warranty - Gastrodomus DOTTO Bedienungsanleitung

USE AND MAINTENANCE.
It is very important to dedicate a short time for the maintenance of your refrigerator in order to maintain it in
perfect efficiency and for a long life-time.
- Every week clean the air filter placed inlet the fan of the refrigerator to avoid the infiltration of flour, dust,
grease, oil, etc.
- The air filter removal is easy and does not need particular tools: just a little pressure on the two sides of the
safety grid occurs to lift it, then remove the filter
- For a proper cleaning it is necessary to immerse the filter in warm water added with detergent, rinse it and
wipe with a cloth. If the filter is only covered with dust an air blow is sufficient to clean it.
- Before replace it in its site control it is not damage or unusable: in this case you have to replace it with a new
one of the same type and thickness (the manufacturer always provides some spare parts).
- Regularly clean the refrigerator (once a week at least) using a sponge and warm water: it is strictly forbidden
to use pointed or cutting metal objects, solvents or aggressive chemicals.
- Sure before cleaning your refrigerator disconnect the plug from the wiring and wait a few minutes in order to
permit the melting of the frost on the inner walls.
IT IS STRICTLY FORBIDDEB AND EXTREMELY DANGEROUS to throw water or sprinklings on
the electrical circuits (fan, suction grids, switch, thermostat, etc.)
OPERATION PROBLEMS AND SOLUTIONS.
(1) – THE REFRIGERATOR DOES NOT TURN ON
SOLUTIONS:
- First check the socket is connected and the plug supplies current regularly
- If the refrigerator does not turn on again, (green light off) check the power cable is not damage and if so, only
a technician can replace it.
(2) – THE REFRIGERATOR DOES NOT COOL OR IT DOES NOT REACH THE PRE-SET
TEMPERATURE
SOLUTIONS:
- Check the thermostat is on and set on the right temperature so that lower than that of the environment, on the
display of the control unit check the operating LED is on and the compressor is on work (you should hear the
noise of the motor)
After five working minutes control the condenser (aluminium exchanger placed laterally behind the perforated
grid) exhales an hot airflow from its upper side. If not, it could be a problem on the compressor or a lack of gas
from the refrigerant circuit or the fan is blocked so you have to contact a technician.
- Control the condenser is dirty or obstructed: in that case clean it using a jet of compressed air
- Control that the room temperature is not over 40°C
(3) – THE CONTROL UNIT GOES INTO ALARM
- If the control unit beeps it means the maximum required time to allow the refrigerator reaches the set
temperature is over.
SOLUTIONS:
- Carry out the same controls mentioned in point (2)
- If the display shows blink characters please contact the after-sale service
(4) – THE CONTROL UNIT SHOWS A FAILURE (ERR)
SOLUTIONS:
It means the probe of the thermostat doesn't work properly and you must replaced it. Contact the after-sale
service

WARRANTY

The warranty on our refrigerators is valid for 12 months from the date of delivery of the machine; the date is on
the transport document signed by the purchaser or by an authorized delegated.
During the period of the warranty and if there are construction faults directly attributable to the manufacturer
and not due to liability of the purchaser, the manufacturer will supply, on his discretion:
(a) the replacement of the non-repairable parts
(b) the repairing of all repairable parts
5