Complete Reset - Hafele Dialock DT 700c Betriebsanleitung

12.2 Complete reset

A complete reset resets the terminal to the factory settings. All data is cleared. The terminal
then has to be reconfigured (
A complete reset is required in the following cases:
• Complete erasing of all data (e.g. in the event of return to stocks / warehouse).
• Resetting of software operation to stand-alone operation (SA).
Prerequisites:
1. Insert the key, turn it as far as it will go in the
opening direction and hold it there in position.

Red LED illuminates after 2 seconds.

White LED flashes.
3. When the signal tone sounds, DO NOT release
the key, but hold it in the stop position for
> 2 seconds.

Red and white LEDs flash quickly.

The complete reset is complete.

The door terminal switches to
commissioning mode

( 7. Commissioning, page 40)
The complete reset can also be carried out with the MDU 110 mobile data transfer unit

( MDU 110 operating instructions
If you have any questions concerning the MDU 110, please contact your responsible
Dialock technician or visit www.hafele.com.
54

7. Commissioning, page 40.).
Key for single profile cylinder
DT 710c
2. Present any user key.
*Note: For the DT 710c, guide the user key
directly towards the antenna and key.

DT 710c
4.
)
Acoustic signal is heard. White LED flashes.
DT 710c