Height Adjustment; Securing Child - Nuna REBL Gebrauchsanweisung

2 Rearward facing mode assembled as
The ISOFIX connectors must be attached and locked onto
the ISOFIX anchor points.
The load leg must be installed correctly with green indicator.
(13)-2

Height Adjustment

for Head Support and Shoulder Harnesses
Check that Shoulder Harness Straps are set at the proper height.
Shoulder Harness Straps must be at a height nearest to your
(14)
childs shoulders , but not above the shoulder line.
If the Shoulder Harness Straps are not at the proper height, the
child might be ejected the child restraint if there is a crash.
Squeeze the head support adjustment lever
up or down on the head support until it snaps into one of the 7
positions. The head support positions are shown as

Securing Child

After the child is placed into the seat, check whether the Shoulder
Harness Straps are at proper height.
1 While pressing the adjustment button located at the front of the
child restraint, pull the two Shoulder Harness Straps of the child
(18)
restraint.
23
(13)
(13)-1
(15)
(16)
, while pulling
(17)
.
2 Unlock the buckle of the harnesses by pressing the red button.
(19)
3 Fix the buckles on the both sides of seat to make placing the
(20)
baby more convenient.
4 Use Infant Insert
Infant insert is for children's protection.
Detach the snaps on
the head support to
remove the head
portion of the insert.
We recommend
using the full infant
insert while the baby
is under 60 cm or
until they outgrow
the insert. The infant
Remove the infant
insert increases side
insert cushion by
impact protection.
detaching the snaps
to allow more space
when the infant does
not fit comfortably.
5 Place the child into the child restraint and lock the buckle. Please
(22)
refer to.
6 Tighten the shoulder harness straps by pulling the adjustment
(23)
webbing.
Make sure the space between the child and the Shoulder
Harness Straps is about the thickness of one hand.
(21)
Remove the head
support portion of
the infant insert
when the child's
head no longer fits
comfortably.
Remove the body
portion of the infant
insert when the
infant's shoulders no
longer fit comfortably.
1
The cushion can
be used separately
without being
attached to the
insert to bolster
2
the infant's back
for more comfort.
24