Changing The Door Hinge - Waeco COOLMATIC MDC-50 Bedienungsanleitung

COOLMATIC MDC Series
6.2 Sealing system
The cooling device has a locking mechanism to protect it during transport.
The following settings are possible:
– Position 1 (transport lock): (fig. 3 1, page 4) The door is locked and
secured. To open the door, turn the bolt to position 2.
– Position 2 (releasing transport lock): (fig. 3 2, page 4) The door can
be opened.
– Position 3 (VENT position): (fig. 3 3, page 4) The door is slightly
open, but fixed in position. Use this position, for example, if you are not
going to use the device for a long time.
6.3

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
To change the door hinge, proceed as follows (fig. 4, page 5):
➤ Remove the upper door hinge (fig. 4 1, page 5).
➤ Carefully lift out the door.
➤ Remove the threaded pins (fig. 4 2, page 5).
➤ Pull the locking hook (fig. 4 3, page 5) off the rod.
➤ Remove the locking plate (fig. 4 4, page 5) and fit it on the opposite side.
➤ Pull the rod downwards and out and put it in the other side.
➤ Fasten the locking hook (fig. 4 3, page 5) back on the rod.
➤ Detach the top and bottom lock holders (fig. 4 5, page 5) on the left side.
➤ Detach the top and bottom door hinges (fig. 4 1, page 5) on the right
side.
➤ Fasten the top and bottom door hinges (fig. 4 1, page 5) to the left side.
➤ Fasten the top and bottom lock holders (fig. 4 5, page 5) to the left side.
Setting up and connecting the cooling device
27