Changing The Door Hinge; Connecting The Refrigerator - Waeco CoolMatic CRX0050 Montage- Und Bedienungsanleitung

CRX0050, CRX0065, CRX0080
 Condensate is produced when the refrigerator is operating normally. You
can either wipe up the condensate in regular intervals, or drain it through
an outlet in the rear of the refrigerator.
Proceed as follows to install the refrigerator:
➤ If you wish to drain the condensate through a hose:
Remove the drain plug (fig. 6 1, page 5).
➤ Connect a hose with an inner diameter of 10 mm to the outlet port
(fig. 6 2, page 5).
➤ Undo the transport lock (chapter "Releasing the lock" on page 48).
➤ Open the refrigerator door.
➤ Remove the blanking plugs (fig. 7 2, page 6).
➤ Push the refrigerator into the recess.
➤ Fix the refrigerator in place using suitable screws (fig. 7 1, page 6).
➤ Press the blanking plugs (fig. 7 2, page 6) into the openings.
7.3

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in fig. 8, page 6 to fig. 0, page 7 to change the
hinges.
7.4

Connecting the refrigerator

Connect the refrigerator to DC power
A
NOTICE!
 To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and avoid any additional
circuits.
Therefore avoid additional switches, plugs or power strips.
 Disconnect the appliance and other electric consumers from
the battery before you connect the battery to a quick charging
device. Overvoltage can damage the electronics of the appli-
ance.
EN
Installing and connecting the refrigerator
41