Safety Rules; Identification Data - Videotec DTMRX2 Betriebsanleitung

2 Safety rules

The DTMRX2 (DTMRX224) receiver complies with current legislation and standards regarding electrical
safety, electromagnetic compatibility and general requirements in force at the time of this manual's publication.
Nevertheless, in order to ensure the users' safety (installer technician and operator) the following warnings are
specified in order to work in maximum safety:
 The appliance (and the whole system of which it forms part) must only be installed by authorised, skilled
technical personnel.
 The appliance must only be opened by authorised, skilled personnel. Tampering with the appliance will
invalidate the terms of the guarantee
 Connect the system to a power supply that corresponds to the indications on the identification labels (see
the next section Identification data)
 The receiver should be connected to the power supply network using a multipolar switch with a minimum
open contact distance of 3mm for each pole.
 The power supply outlet should be connected to earth in accordance with the legislation in force
 Before moving or carrying out technical work on the appliance, disconnect the power supply to the receiver
 The appliance is to be considered OFF only when the power supply is disconnected and the connection
cables to other devices have been removed
 Use cables with an appropriate cross section (see the section on cables)
 Do not use power cables with signs of wear or ageing, since they could expose the user to serious safety
hazards
 Install the cables so they do not get in the way of the operator
 Do not use the appliance in the presence of inflammable substances
 Do not allow children or incompetent persons to use the appliance
 Make sure the appliance is fixed firmly and safely
 For technical services refer only and exclusively to authorised technical personnel
 Keep this manual carefully for future consultation

3 Identification data

There is a label on the receiver containing:
 Product identification code
 Product serial number
 Power supply voltage (Volts)
 Frequency (Hertz)
 Consumption (Watts)
 IP protection rating
There is a label on the package containing:
 Product identification code (Extended 3/9 Bar-code)
 Product serial number (Extended 3/9 Bar-code)
 Short description of the product
 Power supply voltage (Volts)
 Frequency (Hertz)
 Consumption (Watts)
 IP protection rating
Before installing, make sure that the receiver's power supply specifications correspond to the specifications
required. The use of inappropriate equipment may subject personnel and the system itself to serious safety
hazards.
Page 3 MNVCDTMRX2A_1511_EN