IARP DELIGHT LITE Serie Betriebsanleitung Für Betreiber Seite 19

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
16. DISPENSER WASH ASSEMBLY (Optional)
To assemble the dispenser wash, proceed as follows:
Screw in the dispenser wash support (A) with the dispenser
wash (B) using the screw (C) on the back of the equipment.
With water recirculation:
• Fasten the water filling joint (3) with the incorporated valve,
positioned as in the illustration, to the tank (2) using the
fastening nut (4);
• Connect the stainless steel "overflow" tube (7) to the
bushing (6) and fasten it to the tank with the nut (5);
• Connect the water filling joint (3) to the rubber tube to a
tap and fill the tank (2) of clean water;
• Connect the rubber tube to the bushing (6) and drain the
excess water or dirt (filtered from the cover/partition (8))
into a sink.
Without water recirculation:
• Fasten the water filling joint (3) with the valve, positioned
as in the illustration, to the tank (2) using the fastening nut
(4);
• Connect the stainless steel "overflow" tube (7) to the
bushing (6) and fasten it to the tank with the nut (5);
• Connect the rubber tube to the bushing (6) and drain the
excess water or dirt (filtered from the cover/partition (8))
into a sink.
• Manually fill the tank with clean water.
DELIGHT LITE
DELIGHT PRIME
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1 9 / 6 8
PAGE
N° DOC
A
C
UM000327
B