Attaching The Network Cable; Aligning The Camera; Zoom And Focus Settings - Abus TVIP91 Serie Bedienungsanleitung

6.4 Attaching the network cable

The maximum network cable (CAT7) length from the camera to the nearest active network point
(e.g. network switch) should not exceed 100 metres.

6.5 Aligning the camera

Instructions for how to align the camera are given in the quickstart guide for the relevant IP
camera TVIP9XXXX.

6.6 Zoom and focus settings

TVIP91100/TVIP91300/TVIP91600/TVIP91700
The cameras have a built-in fix lens. The focal length is dependent on the lens and the focus is
already factory-set. It is not possible to change the angle of view or the focus.
TVIP92100/TVIP92300/TVIP92600/TVIP92610/TVIP92700
The cameras have a built-in Motor Vario zoom lens. It is possible to change the zoom factor or
adapt the focus via the camera's web interface ("master" or "installer" access).
The zoom factor can be changed in stages, whereas the focus is automatically set for each of
these zoom factors. It's possible to change the focus of each zoom factor via the camera's web
interface ("master"/"installer" access). The change will be saved to the camera. When the camera
undergoes a factory reset, the factory-set zoom/focus relationship is reset too.
It is also possible to operate the zoom function using the two reset buttons. You can find a more
detailed description of this under point 6.10 "Restoring factory settings (reset)".
TVIP92500
Settings for zoom and focus are made manually in the lens to be installed (lens is not included in
the scope of delivery).
74