General Power Tool Safety Warnings; Work Area Safety - Parkside PFBS 12 B3 Originalbetriebsanleitung

SMPS – switched-mode
power supply
Charging time:
Safety transformer,
short-circuit-proof
Protection class:
Polarity:
Protection type
Fuse (internal):
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty K:
Wear hearing protection!
Total vibration value:
a = 1,216 m/s 2
h, SG
Uncertainty K: 1.5 m/s
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with
a standardised test procedure and can be
used for comparison of the power tool with
another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
PFBS 12 B3
approx. 1 hour
II / (double insulation)
IP20
Protection against solid
objects with a diameter of
more than 12.5 mm
T2A
2 A
L = 61.8 dB (A)
pA
K = 3 dB
pA
L = 72.8 dB (A)
WA
K = 3 dB
WA
2
WARNING!
► Depending on the manner in which the power
tool is being used, and in particular the kind of
workpiece that is being worked, the vibration
and noise emission values can deviate from
the values given in these instructions during
actual use of the power tool.
► Try to keep the load as low as possible.
Measures to reduce the vibration load are,
e.g. wearing gloves and limiting the working
time. Wherein all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool is
switched on but running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result
in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ IE │
19 ■