Cable Connectors - LOTRONIC ibiza LIGHT LMH-MINIWASH Bedienungsanleitung

188-217
218-255
15 0-255
16
0
1-7
7-39
40-72
73-105
106-138
139-140
141-167
168-195
196-223
224-251
252-255
17 0-255
18 250-255
3. SETUP
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
3.1 Fuse Replacement
With a flat head screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
The fuse is located inside this compartment. Remove using a flat head screwdriver.
3.2 Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial
data link distance: 500 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 32 fixtures
Data Cabling
To link fixtures together you must use data cables. If you choose to create your own cable, please use data-grade
cables that can carry a high quality signal and are less prone to electromagnetic interference.

CABLE CONNECTORS

Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
©Copyright LOTRONIC 2016
Motor Sound control 1
Motor Sound control 0
Motor auto running speed from fast to slow
LED Auto/Sound control
Other Channels work
Gradual Change
LED Auto running 0
LED Auto running 1
LED Auto running 2
LED Auto running 3
LED Auto running 4
LED Sound control 0
LED Sound control 1
LED Sound control 2
LED Sound control 3
LED Sound control 4
LED Auto running speed from slow to fast
Reset after 5s
LMH-MINIWASH Page 5