Renkforce GM106 RGB Moving Head Bedienungsanleitung Seite 34

SLAu = Slave mode
• The display indicates Son.
• The light effect can be used as a unit in a master-slave chain. In that case, the integrated controller of
the master device controls the connected slave devices.
• The connection of this kind of master-slave chain is described in „Setup of a master-slave chain".
• The master unit must work in one of the four operating modes described above without DMX controller
in this mode and controls the slave devices (setting SLAu).
d) Use with DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 5 or 13 DMX channels depending on DMX operating mode.
Setting the DMX operating mode (channel number)
• Press MODE/ESC (1) repeatedly until 13CH or 5CH appears.
• Select the desired DMX channel number with the buttons UP (2) or DOWN (3) and confirm your input with
the button ENTER (4).
13CH = 13 channel DMX mode
5CH = 5 channel DMX mode
Setting the DMX starting address
• Press MODE/ESC (1) repeatedly until dxx appears (xxx defines the DMX start address).
• Select the desired DMX start address with the buttons UP (2) or DOWN (3) and confirm your input with
the button ENTER (4).
34