Setting And Starting A Washing Programme - Atag VA6311NF Benutzerinformation

30
Do these steps to move the upper basket
to the higher position:
1. Move the front runner stops (A) out.
2. Pull the basket out.

Setting and starting a washing programme

Starting the washing programme
without delay start
You can set the washing programme
with the appliance door open or
closed.
If the door is open, you can change the
setting, the appliance starts to operate
only after you close the door.
If the door is closed, the appliance
starts to operate after 3 seconds from
the setting of the washing programme.
1. Activate the appliance. Make sure that
the appliance is in setting mode.
2. Set the washing programme.
• The related programme indicator
comes on. All the other programme
indicators go off.
• The programme time flashes in the
display.
• The phase indicators of the set wash-
ing programme come on.
3. Close the appliance door, the washing
programme starts automatically.
• The programme time flashes no more
in the display.
• Only the phase indicator of the phase
in operation stays on.
Starting the washing programme with
delay start
You can set the delay start with the ap-
pliance door open or closed.
If the door is open, you can change the
setting because the appliance starts to
operate only after you close the door.
3. Put the basket in the upper position.
4. Put back the front runner stops (A) in
their initial position.
If the door is closed, the appliance
starts to operate after 3 seconds from
the setting of the delay start.
1. Activate the appliance. Make sure that
the appliance is in setting mode.
2. Set the washing programme.
3. Press the delay start button again and
again until the display shows the time of
the delay start.
• The delay time flashes in the display.
4. Close the appliance door, the count-
down starts automatically.
• The delay time flashes no more in the
display.
• The phase indicators of the set wash-
ing programme go off.
When the countdown is completed, the
washing programme starts automatically.
The indicator of the phase in operation
comes on.
The opening of the appliance door
stops the countdown. When you close
the door, the countdown continues
from the point of interruption.
Cancelling the delay start
The countdown is not operating
1. Press the delay start button again and
again until the display shows the time of
the washing programme.
2. Close the appliance door, the washing
programme starts automatically.