Operation; Charging The Battery - REXROTH NX-BP2-36V Montageanleitung

24/32 Operation

Operation
6
Note:
On delivery, the battery is in deep
sleep; it is activated via the activation
button. If it is inactive for 8 hours, the
battery again enters deep sleep mode.
Note:
Voltage cannot be measured at the
connecting terminals.

Charging the battery

6.1
The battery is delivered partly charged. To
ensure full battery power, fully charge the
battery in the charger before using it for the
first time.
Unsuitable battery chargers might
cause damage!
If it is charged inappropriately, the
battery may be overheated or
damaged!
Only use the original battery charger

(type NX-BC36V / NX-BC36V-CN).
This charger matches the battery
optimally.
Note:
If used properly, the battery can
be recharged at least 500 times.
Charging the battery
Connect the battery charger to a
1.
suitable receptacle using the power
supply cable.
The charging condition indicator is lit
for 3 seconds.
Bosch Rexroth AG, NX-BP2-36V, NX-BC36V, NX-BC36V-CN, 3608870DP0, AA/05.2017
CAUTION
Fig. 4: Inserting the battery into the charger
Insert the battery completely into the
2.
charger.
The battery is charged immediately.
The charging condition indicator shows
thecharging condition of the battery.
Table 4: Charging condition indicator on the
battery
LEDs are
flashing
LEDs are lit
0.5 s ON /
0.5 s OFF
None
1
None
1
None
1, 2
None
1, 2, 3
None
1, 2, 3, 4
None
1, 2, 3, 4, 5
Residual
capacity
0-16%
17-33%
34-50%
51-67%
68-83%
>83%