Appliance Installation; Dismounting The Appliance; Electrical Connection; 10. Troubleshooting - STIEBEL ELTRON CNS 50 UT Handbuch

INSTALLATION
TROUBLESHOOTING
Drill holes at all four markings. Secure the wall mounting bracket
»
with suitable materials (screws, rawl plugs) depending on the
type of wall. With the vertical slots, you can compensate for an
offset fixing hole.
9.3

Appliance installation

Hook the appliance by its slots in the back of the appliance on
»
to all four tabs of the wall mounting bracket simultaneously.
Push the appliance to latch it in position.
»
Turn the locking bolt in the wall mounting bracket fully clockwise;
»
this locks the appliance in place.
Push the safety cap onto the locking bolt to prevent it from loos-
»
ening.
1 Locking bolt
2 Wall mounting bracket
1
1 Appliance
2 Safety cap
3 Locking bolt
WWW.STIEBEL-ELTRON.COM
9.4
Remove the safety cap from the locking bolt.
»
1 Appliance
2 Safety cap
3 Locking bolt
1
Undo the locking bolt in the wall mounting bracket by turning
»
2
it anti-clockwise.
Lift the appliance up slightly and pull it forwards and away from
»
the wall mounting bracket.
9.5
Ensure the on-site supply cable has an adequate cross-section.
»
Ensure a socket or junction box for a permanent power supply
»
is installed at a distance of at least 10 cm from the side of the
appliance.
2
3

10. Troubleshooting

The power cable must only be replaced by a qualified contractor
using original spare parts supplied by us.

11. Appliance handover

Explain the functions of the appliance to the user. Draw special
attention to the safety instructions. Hand the operating and instal-
lation instructions to the user.

Dismounting the appliance

1

Electrical connection

DANGER Electrocution
Carry out all electrical connection and installation
work in accordance with relevant regulations.
DANGER Electrocution
In the case of a permanent connection, the appliance
must be able to be separated from the power supply
by an isolator that disconnects all poles with at least
3 mm contact separation. This appliance is unsuitable
for fixed cables.
DANGER Electrocution
Never install the appliance directly below a wall
socket.
Observe the type plate. The specified voltage must
match the mains voltage.
2
3
CNS UT | 17