Installation Procedure - Gorenje NRS9181CX Bedienungsanleitung

WATER SUPPLY KIT
※ Check the parts below for installing water supply.
Necessary parts are available at your local service
agents.
Connector

Installation Procedure

1. Join connector to the tap water line
Figure A
Connector
Figure B
Place the rubber washer inside the tap connector
and screw onto the water tap.
2. Connect the Water Tube to the refrigerator.
1) Remove the rear cover at the bottom back of the
refrigerator.
2) Insert the fastening ring into the Water tube. (Be careful
to follow the direction of the nut.)
3) Insert the Water Tube into the top of the Water Valve,
turn the nut clockwise to fasten it. (The Water valve is to
the right of the motors.)
4) Check for any bent tubes or water leaks; if so, reckeck
installation procedure.
5) Replace the rear cover. (The Water Tube should be
placed between the groove of the refrigerator back and
motor cover.)
16
Filter Box Water tube
Filter Box Water tube
※Set the tube upright as the figure shows.
3. After installation of Water Supply System
1) Plug in the refrigerator, press the [WATER] button on the
control panel for 2~3 minutes to remove any air (bubble)
in the pipes and drain out the initial water.
2) Check for the water leaks again through the water supply
system(tubes, connectors and pipes). Rearrange the
tubes again and do not move the refrigerator.