Automatic Control Functions; Foam Detection; Overflow Protection System; Dynamic Quantity Control - hanseatic HWM5T110D Gebrauchsanleitung

Page EN-22

Automatic control functions

Automatic control functions
The following functions run automatically. You
cannot change them.

Foam detection

The electronic foam detection makes sure
that more water is added to the first rinse cy-
cle for certain amounts of foam.

Overflow protection system

This system prevents the water from leaking
out over the dispensing drawer. As soon as
a certain water level is exceeded, the outlet
pump will automatically switch on.

Dynamic quantity control

If your appliance is loaded to only half of the
maximum capacity, for certain cycles the
water consumption and cycle duration will
reduce. Also adjust the amount of detergent
accordingly.

Imbalance correction system

This system protects your appliance in the
event of a too-great imbalance once spinning
starts. This can happen with small loads or
with large individual pieces of laundry. The
laundry is distributed again and the spin
speed increased if the laundry distribution is
right.