Click Codes - Konig + Neurath TALO.YOU Bedienungsanleitung

CLICK CODES

Number
of "click-
When
clack"
sounds
Supply of electrical power
1
(*dependent on configuration)
1 Up key pressed
1 Lower blockade detected
1 Lower blockade detected
2 Set container or shelf stop
3 First movement after sensor out
First movement after sensor
3
reinserted
4 Delete container or shelf stop
Container stop or shelf stop too near
6
in the middle
7 Motor cable pulled or missing
7 Table moves at an angle
Status Information
Normal operation: The system is
functioning without any problems.
Faulty operation: The controller does
not have any firmware: Only 1 click
sounds.
Reset: Initialisation movement is
required.
Reset: Table has reached the Reset
position during the initialisation
movement. The -key can be released.
Reset: Initialisation movement has
ended; key continues to be pressed.
Release the key.
Confirmation: The position was
successfully saved.
Caution: A previously detected sensor
has been removed. Normal operation
can continue.
Note: A sensor was reconnected after
a previously detected sensor had been
removed. Normal operation can
continue.
Confirmation: The position was
successfully deleted.
Warning: An attempt is being made to
set the container stop or shelf stop too
near the middle of the total stroke.
Warning: Motor cable absent when
connecting to the mains, or has been
disconnected during operation. Connect
the missing motor cable with the
controller.
Warning: Slanted position of the table
has become too big. Carry out an
initialisation movement.
65