Crane Transport - Pfannenberg DTI 6401 Serie Betriebsanleitung

ENG
4.2.2

Crane transport

DANGER
Danger of death from suspended loads
Tipping or falling loads can cause severe to fatal injuries.
• Never stand beneath suspended loads.
• Only use approved lifting gear and slings which are designed for the total weight of the attached load.
• Only use slings/load handling devices in technically perfect condition.
• Observe the sling points and center of gravity of the load.
• Secure loads with suitable devices.
WARNING
Risk of injury due to improper crane transport
Moving switch cabinets with integrated cooling units can lead to accidents.
• Lifting by M6 jack rings is only permitted for the cooling unit.
• Ensure that jack rings and unit threads are not damaged or deformed.
• Only use jack rings with a sufficient thread length according to DIN 580 and check that they are securely fitted.
Fig. 8: M8 jack rings DTI/DTS cooling units
1 M8 jack rings
The cooling units have screw-in threads for M8 jack rings. Cooling units with bolted M8 jack rings may be used for crane
transport.
Requirements
• The unit has been completely unpacked.
• Observe the minimum screw-in depth of the M8 jack rings according to DIN 508.
• The M6 jack rings and cooling unit threads are free of damage (corrosion, deformation).
• The fastening screws (2×) were removed from the unit cover.
Procedure
1. Screw in the M8 jack rings (2×) completely.
2. Check that the M6 jack rings are securely fitted in the cooling unit as prescribed.
The M8 jack rings are screwed in the cooling unit and the unit can be moved.

Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 400 / 460 V, 3~ | 086100007d
2 Unit cover fastening screws
G00006
24/60