Bosch UniversalHedgeCut 50 Originalbetriebsanleitung Seite 14

14 | English
That the declared vibration total value(s) and the declared
noise emission value(s) may also be used in a preliminary as-
sessment of exposure.
That the vibration and noise emissions during actual use of
the power tool can differ from the declared values depend-
ing on the ways in which the tool is used especially what kind
of workpiece is processed; and of the need to identify safety
measures to protect the operator that are based on an estim-
ation of the exposure measures in the actual conditions of
use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running
idle in addition to the trigger time).
Noise emission values determined according to EN
62841-4-2:2019.
Typically the A-weighted noise levels of the product are:
Sound pressure level 75 dB(A); sound power level
95 dB(A). Uncertainty K = 2.0 dB.
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 62841-4-2:2019:
2 2
a = 2.5 m/s , K = 1.5 m/s .
h
Operation
Pay attention to the mains voltage. The voltage of the
u
power source must match the voltage specified on the
rating plate of the machine.
Troubleshooting
Problem Possible Cause
Hedgecutter does not Power turned off
operate
Mains socket faulty
Mains cable damaged
Extension cable damaged
Fuse faulty / blown
Hedgecutter operates Internal wiring of garden tool defective
intermittently
On/Off switch defective
Motor runs but blades Internal Error
remain stationary
Cutting blade hot Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of lubricant
Excessive vibrations/ Machine defective
noise
F 016 L94 168 | (20.01.2021)
Switching ON/OFF (see figures C and D)
To switch ON, firstly press and hold the lock-off button for
On/Off switch (3). Then press the On/Off switch (2) and
keep it pressed.
To switch OFF, release the lock-off button for On/Off switch
(3) and then release the On/Off switch (2).
Sawing Function
Although the tooth opening allows wood to be cut up to
Ø 20 mm, the tip of the blade is designed to cut wood up to
Ø 25 mm.
Working with the Hedgecutter (see figure E)
Move the hedgecutter evenly forward along the cutting line.
The double edge cutting blade enables cutting in either dir-
ection, or with a side to side motion.
Cut the sides of the hedge first, then the top.
To cut the sides straightly, we recommend cutting from bot-
tom to top in the direction of growth. Younger stems tend to
move outwards when cutting them from top to bottom, res-
ulting in shallow patches or holes in the hedge.
To reach a level finish, fasten a piece of string along the
length of the hedge at the required height and use as an
alignment guide. Cut the hedge just above the string.
Pay attention that no objects such as wires are cut. The
blade or drive can be damaged.
Corrective Action
Turn power on
Use another socket
Check mains cable; if damaged, contact Service
Agent
Inspect extension cable, replace if damaged
Replace fuse
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Have blade sharpened
Have blade inspected/overhauled
Apply lubricant spray
Contact Service Agent.
Bosch Power Tools