Before First Use - IKEA skinande Handbuch

ENGLISH
Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse aid
and salt. The related indicators are off.
The programme duration can increase.
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode. Refer to 'SET-
TING AND STARTING A PROGRAMME'.
2. Press and hold function buttons (D) and
(E) at the same time until the multitab in-
dicator comes on.
The option stays on until you deactivate it.
• Press and hold function buttons (D) and
(E) at the same time until the multitab in-
dicator goes off.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Deactivate the multitab option.
2. Set the water softener to the highest lev-
el.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener. Contact your local water au-
thority to know the water hardness in
your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
Acoustic signals
The acoustic signals operate in these condi-
tions:
• The programme is completed.
• The level of the water softener is adjusted
electronically.
• The appliance has a malfunction.
Factory setting: on. You can deactivate
the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode. Refer to 'SET-
TING AND STARTING A PROGRAMME'.
2. Press and hold function buttons (B) and
(C) at the same time until the indicators
of function buttons (A), (B) and (C) flash.
3. Press function button (C),
• The indicators of function buttons (A)
and (B) go off.
• The indicator of function button (C)
continues to flash.
• The display shows the setting of the
acoustic signals.
4. Press function button (C) to change the
setting.
5. Deactivate the appliance to confirm.
4. Open the water tap.
5. Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do not
load the baskets.
If you use the combi detergent tablets,
activate the multitab option.
8
On
Off