The
, + and – buttons cannot be located on
the TV.
See below illustration for location of the buttons
on the TV.
Rear of TV
The illumination LED is turned on.
If you do not wish to light up the illumination LED,
you can turn it off.
Press HOME, then select [Settings] t
[Illumination LED] t [Off].
Cannot connect to a wireless router by WPS
(Wi-Fi Protected Setup).
If you use WEP security, select [Easy] t [Wi-Fi] t
[Connect by scan list]. Then, select the network
name (SSID) you want to connect.
Cannot find the required network name in
network setup.
Select [[Manual entry]] and press
network name.
Specifications
System
Panel system
LCD (Liquid Crystal Display) Panel, LED Backlight
TV system
Depending on your country/area selection/TV
model
Analogue: B/G, D/K, L, I
Digital: DVB-T/DVB-C
Satellite*: DVB-S/DVB-S2
Colour system
PAL, SECAM, NTSC3.58 (Video only), NTSC4.43
(Video only)
Channel coverage
Depending on your country/area selection/TV
model
Analogue: UHF/VHF/Cable
Digital: UHF/VHF/Cable
Satellite*: IF Frequency 950-2,150 MHz
Sound output
10 W + 10 W
Wireless technology
Protocol IEEE802.11ac/a/b/g/n
(IEEE802.11ac may not be available depending on
countries/regions.)
Bluetooth Version 4.1
* Not all the TV sets have DVB-T2 or DVB-S/S2
technology or satellite antenna terminal.
Input/Output jacks
to enter
Antenna (aerial)/cable
75 ohm external terminal for VHF/UHF
Satellite antenna
Female F-Type Connector, 75 ohm.
DiSEqC 1.0, LNB 13 V/18 V & 22 kHz tone, Single
Cable Distribution EN50494.
/
21-pin scart connector (CENELEC standard)
including audio/video input, RGB input and TV
audio/video output.
t
o
/
Video/Audio input (mini jack)
DVB-T2*
AV1
AV2
GB
15
GB