Troubleshooting - Scheppach deco-flex Original Bedienungsanleitung

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.

15. Troubleshooting

WARNING
Always switch the machine off and remove the mains
plug prior to all maintenance and cleaning work.
Fault Possible cause
Saw blade without Saw blade clamping screw (28/29) not
pins loosens after tightened enough
switching off the
engine
Motor does not start Failure mains fuse
Extension cable defect
Fine-wire fuse defective
Connections on the motor or switch defect
Motor or switch defect
Saw blades brake Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Saw blade oscillates, Holders not aligned
not aligned straightly.
28 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Tighten the saw blade clamping screw (28/29)
Check the mains fuse.
Change extension cable.
Check the fine-wire fuse and, if necessary,
replace it with a fine-wire fuse of the same type.
Have it checked by an electrician.
Have it checked by an electrician.
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders. Bring
the holders into the vertical position and tighten
the screws again.