DGM IPS-2701WPH Bedienungsanleitung Seite 16

ENGLISH
FREQUENT ASK QUESTIONS
Errors
Power Pilot lamp not bright
Bleak picture
Flash image or water wave image
Power pilot lamp bright, but no
image display on the screen
Color lose(Red, Green, Blue)
Picture is not in middle or
incorrect size
The images have color shading
(white looks not pure white)
Weak brightness and contrast
Picture horizontal or vertical
interference
The Clock controls the quantity of scanned pixel at each line. If the frequency is not correct, vertical
stripes may appear on screen, and appear incorrect screen width. FOCUS adjust phase of Point
frequency signal, a wrong phase adjustment will cause picture appear horizontal interference. Use
"dot-pattern" or Win95/98/2000/ME/XP shutdown pattern to adjust CLOCK and FOCUS.
Possible solution
Whether power on or not
Whether Power cord connected or not
Adjust brightness or contrast ratio
Electronic jamming caused by nearby electrical
equipment
*
Whether computer power is on or off
*
Whether computer graphics has inserted or not
*
Whether computer signal cable properly connected
or not
*
check monitor signal cable and make sure each pin
without bending
*
Press "Caps Lock" key on keyboard to observe pilot
lamp, so as to confirm if the computer is in operation
or not
check monitor signal cable and make sure each
pin without bending
Adjust CLOCK and FOCUS or hot keys (AUTO)
Adjustment RGB color or to choose new color
temperature
When monitor brightness reduce to affect normal use
of the monitor after a period of service, please send
monitor to authorized service organization to repair
Close Win95/98/2000 / ME/XP, adjust CLOCK and
FOCUS or press hot keys (AUTO key )
14