MSI K8N Neo3-Serie Kurzanleitung Seite 20

MS-7135 ATX Mainboard
Floppy Disk Drive Connector: FDD1
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.
CD-In Connector: J1
Chassis Intrusion Switch Connector: JCI1
the chassis is opened, the switch will be short. The system will
record this status and show a warning message on the screen.
To clear the warning, you must enter the BIOS utility and clear the
record.
Serial ATA Connectors: SATA1~SATA4
Each supports 1
and is fully compliant with Serial ATA 1.0 specifications. Each
Serial ATA connector can connect to 1 hard disk device.
E-14
Downloaded from www.Manualslib.com
The mainboard provides a standard floppy disk drive connector that supports
FDD1
This connector is provided for CD-ROM audio.
This connector is connected to a 2-pin chassis switch. If
SATA1~SATA4 are high-speed Serial ATA interface ports.
st
generation serial ATA data rates of 150MB/s
Serial ATA cable
Connect to SATA1/2/3/4
MSI Reminds You...
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise,
data loss may occur during transmission.
manuals search engine
Connectors
Take out the dust cover and
connect to the hard disk
devices
J1
R L
GND
2
GND
1
CINTRU
JCI1
GND
TXN
RXN
TXP
RXP
GND GND