Connections - Omnitronic DJ-28 Bedienungsanleitung

The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use spray cleaners in order to clean the faders!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

4. CONNECTIONS

• Install the device on a plane surface.
• Make sure that the power switch is set to OFF. Before you connect the devices, all units have to be
switched off.
• In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• The Master-output can be connected via the RCA-sockets. Make sure that the sockets are set properly
(L & R). The output signal of the Master-signal can be adjusted via the Master-control.
• The DJ-28 features one separately controllable microphone channel (DJ MIC). This microphone can be
connected via the ¼" MIC jack-socket on the faceplate.
Occupation balanced stereo-1/4" jack-plug:
• You can connect up to 2 record players using the PHONO 1 sockets and PHONO 2 on the rearpanel. You
can only control the record player signal after you switched the PHONO/LINE switches to PHONO. The
signal is then controlled via the CH-1 and CH-2 faders.
• Connect your CD-player, DAT-recorder, cassette deck, tuner, tape recorder or all other line signals to the
LINE input-sockets on the rearpanel. You can only control the line signals after you switched the
PHONO/LINE switches to line. The signal is then controlled via the respective faders.
• Connect the connection cable of the power-unit with the AC IN-socket. Plug the power unit into your outlet.
13/31 10006556_V_1_0.DOC