National Instruments SCXI Serie Schnellstartanleitung Seite 7

Step 5. Attach Sensors and Signal Lines
Attach sensors and signal lines to the terminal block, accessory, or module terminals for each installed
device.
You can view and print a connection diagram for NI-DAQmx tasks and virtual channels in your system
through the DAQ Assistant. Select the task or virtual channel and click the Connection Diagram tab.
Select each virtual channel in the task to view the terminal names and numbers for connections from
sensor to connector block.
Pin assignments are also in the device documents on the Device Document Browser, accessible from
Start»All Programs»National Instruments»NI-DAQ»Browse Device Documentation after you
install it, and from Device Terminals in the Measurement and Automation Explorer Help for
NI-DAQmx, accessible from the MAX Help menu.
Refer to the module user manual for more information about configuring the switch or jumper settings
on the hardware.
For information on sensors, refer to
can access from Start»All Programs»National Instruments»NI-DAQ»NI-DAQmx Help. For
information on IEEE 1451.4 TEDS smart sensors, refer to
Step 6. Attach the Terminal Blocks
SCXI Chassis or PXI/SCXI Combination Chassis
If you installed direct-connect modules, skip to
Attach the terminal blocks to the front of the modules. Refer to
terminal block and module combinations. Refer to the TBX installation guide if you are using a TBX
terminal block.
1 Modules with Installed Terminal Blocks
2 Attaching a Terminal Block to the SCXI Module
SCXI Quick Start Guide
or Sensors in the NI-DAQmx Help, which you
ni.com/sensors
Step 7. Install the Cable
1
®
5
4
3
2
1
2
3
3
Figure 8. Attaching Terminal Blocks
6
.
ni.com/zone
Adapter.
ni.com/products
SCXI Module Front Panels
to determine valid
ni.com