Starting The Dishwashing Programme; Unloading The Dishwasher - hanseatic HGU4582D10J7736EI Gebrauchsanleitung

Page EN-24 Dishwasher operation
Starting the dishwashing
programme
(6)
1. Start the programme with the button
(11).
If you
– have not set up a start delay, the pro-
gramme cycle will begin after a few sec-
onds.
– have set up a delayed start, the display
will initially still show the start-delay du-
ration (6); the dots between
number of hours will flash. After the start
delay runs out, the programme will start.
During the programme the display will
show the time remaining (6); the dots be-
tween hour and minute numbers will flash.
At the end of the programme cycle, an
acoustic signal will sound 8 times and the
display will show
End
2. Switch the dishwasher off using the but-
ton (18).
3. Turn the tap off.
4. Wait a little while before unloading the
dishwasher.

Unloading the dishwasher

CAUTION!
Risk of scalding!
If you open the dishwasher door, hot
steam will come out.
Maintain a suffi cient distance from
■
the door and do not hold your head
or upper body directly above the
open door.
(11)
and the
H
.
Make sure that children do not open
■
the door if the programme has only
fi nished a short time ago.
Only open the door slightly to allow
■
the steam to escape more easily.
Allow the dishes to cool before un-
■
loading the dishwasher.
Tripping hazard!
An open dishwasher door can quickly
become a tripping hazard.
Close the door after every use.
■
Only leave the door slightly open to
■
cool down.
NOTICE
Risk of damage!
Make sure that children and pets do
■
not stand on the open door.
Once the programme has come to an end
and the dishes have cooled, you can remove
them.
1. When unloading the dishwasher, start
with the lower rack and then unload the
upper rack. This will prevent water drip-
ping onto the lower layer of dishes from
the top layer of dishes.
2. Leave the dishwasher door slightly open
so that the inside of the dishwasher can
also cool off and dry out.
If no further settings are made, the appliance
will automatically switch off/enter standby
mode after 15 minutes.