Preparing For Use; Installing The Charger; Charging The Appliance; Using The Appliance - Philips Wet&Dry FC6145 Bedienungsanleitung

English
8

preparing for use

installing the charger

Attach the charger to the wall as shown in the igure. (Fig. 2)
1
If you attach the charger to the wall, the space between the screw holes
has to be 12cm.
You can also place the charger on a horizontal surface (e.g. a table
2
or desk) (Fig. 3).
Wind excess mains cord around the reel in the back of the charger
3
and pass the cord through the slot (Fig. 4).

Charging the appliance

Charge the appliance for at least 16 hours before you use it for the irst
time.
1 Make sure the appliance is switched off.
2 Put the adapter in the wall socket.
Place the vacuum cleaner on the charger (Fig. 5).
3
Make sure you place the opening in the back of the vacuum cleaner
-
on the hook of the charger (Fig. 6).
, The charging light goes on to indicate that the appliance
is charging (Fig. 7).
Note: The charging light stays on as long as the appliance is in the plugged-in
charger.
Note: The charging light does not give any information about the battery
charge level of the vacuum cleaner.

using the appliance

Push the on/off slide forwards to switch on the appliance (Fig. 8).
1
Push the on/off slide backwards to switch off the appliance (Fig. 9).
2