Installation; General Information; Electrical Installation - AEG MSC2544S Benutzerinformation

36 www.aeg.com

12. INSTALLATION

12.1 General Information

• The microwave is for built-in use only.
• The cabinet can not have a back wall
• Put the microwave far away from
• If the microwave is to close to the TV
• If you transport the microwave in cold

12.2 Electrical installation

This microwave is supplied with a main
cable and main plug.
Downloaded from www.Manualslib.com
WARNING!
Refer to Safety chapters.
CAUTION!
Do not block the air vents. If
you do that, the appliance
can overheat.
CAUTION!
Do not connect the
appliance to adapters or
extension leads. This can
cause overloading and risk
of fire.
CAUTION!
The minimum installation
height is 85 cm.
It must be placed on a stable and flat
surface.
in the place where the microwave is
located.
steam, hot air and water splashes.
and radio it may cause interference in
the received signal.
weather, do not activate it
immediately after the installation. Let
is stand in the room temperature and
absorb the heat.
WARNING!
Only a qualified person must
do the electrical installation.
The manufacturer is not
responsible if you do not
follow the safety precautions
from the chapter "Safety
Information".
manuals search engine
The cable has an earth wire with an
earthing plug. The plug must be
plugged into an outlet that is properly
installed and earthed. In the event of an
electrical short circuit, earthing reduces
the risk of electric shock.
12.3 Installing the microwave
1. Check if the dimensions of the
furniture meet the installation
distances.
C
D
A
B
Installation distances
Dimension
A
B
C
D
2. If the cabinet depth is over 300 mm,
put the template on the bottom of
cabinet and check if it fits. If yes,
mark the spots for screws. Remove
the template and fix the bracket with
the screws in the marked spot.
Skip this step if the
cabinet depth is 300
mm.
mm
450 + 2
560 + 8
550
45