Dometic POWER & CONTROL TEC29 EV Montageanleitung Seite 30

Connecting the electrical power to the generator
➤ Connect the negative terminal of the battery using a cable with a suitable cross-
section (see above) as follows:
– to the earth connection on the generator (fig. h 1, page 11) or
– via the inserts at the side of the generator (fig. h 2, page 11)
➤ Connect the earth connection on the generator to the vehicle chassis.
Remove any paint or rust from the chassis if necessary to ensure good contact.
➤ Protect the connections by applying lubrication.
10.6 Configuring the automatic mode
I
NOTE
• You can only use automatic mode:
– if the vehicle is stationary and the ignition is switched off
• To shorten charging times, an additional charging unit with at least
20 A can be installed between the generator and disconnector
switch, especially if batteries with a capacity of more than 60 Ah are
used.
• Make sure that one of the two instructions stickers provided is clearly
visible affixed next to the external control panel.
• Make sure that the second instructions sticker is affixed to the gener-
ators front door.
In automatic mode, the generator switches on automatically and charges the battery
if the voltage of the connected battery is too low.
The generator switches off automatically once the battery has been fully charged.
The circuit diagram for the automatic mode can be found in fig. i, page 12.
➤ Connect the black wire to terminal 6 of the 6-pin plug on the extension cable.
➤ Connect the black wire to switch 1 (not included in the scope of delivery).
➤ Lead the black wire from switch 1 to the ground through a connection managed
by the ignition key.
30
TEC29 EV
EN