Do not use harsh abrasive cleaners or sharp
metal scrapers to clean the oven door glass
since they can scratch the surface, which
may result in shattering of the glass.
The temperature of accessible surfaces may
be high when the appliance is operating.
The door or the outer surface may get hot
when the appliance is operating.
Keep the appliance and its cord out of reach
of children less than 8 years.
Appliances are not intended to be operated
by means of an external timer or separate
remote-control system.
This product is a Group 2 Class B ISM
equipment. The deinition of group 2 which
contains all ISM equipment in which radio-
frequency energy is intentionally generated and/
or used in the form of electromagnetic radiation
for the treatment of material, and EDM and arc
welding equipment.
For Class B equipment is equipment suitable
for use in domestic establishments and in
establishments directly connected to a low
voltage power supply network which supplies
buildings used for domestic purposes.
MG23F3C1EAW_SW_DE68-03911J_EN.indd 6
INSTALLING YOUR MICROWAVE OVEN
Place the oven on a lat level surface 85 cm
above the loor. The surface should be strong
enough to safety bear the weight of the oven.
1. When you install your oven,
make sure there is adequate
ventilation for your oven by
leaving at least 10 cm (4 inches)
of space behind and, on the sides of the
oven and 20 cm (8 inches) of space above.
2. Remove all packing materials inside the oven.
3. Install the roller ring and turntable. Check that
the turntable rotates freely.
(Turntable type model only)
4. This microwave oven has to be positioned so
that plug is accessible.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualiied persons in
order to avoid a hazard.
For your personal safety, plug the cable
into a proper AC earthed socket.
Do not install the microwave oven in hot or
damp surroundings like next to a traditional
English-6
20 cm
10 cm
above
behind
85 cm of
the loor
10 cm on the
side
8/22/2013 9:44:58 AM