Hendi Party pan Gebrauchsanweisung Seite 5

Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage,
immediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and
a soft cloth.
Operation
Important: Prior to using the pan and lid, clean
them thoroughly.
1. Adjustment: Turn the thermostat knob to "Off"
and plug the thermostat into the pan.
2. Connect the power plug to a suitable electrical-
wall outlet.
3. Turn the thermostat knob to the temperature re-
quired for the dish that is to be prepared.
Boiling, frying, and pot-roasting
Wait approximately 5 to 10 minutes after the pan
has been switched on. When the indicator lamp is
lit, you can start to use the pan.
• When in use, the indicator lamp flashes. This
does not indicate a fault, but shows that the ther-
mostat is operating correctly.
After use
1. After using the pan, turn the thermostat knob to
"Off".
2. Then remove the plug from the power outlet
and remove the thermostat from the party pan.
Caution: The temperature sensor of the thermo-
stat will be very hot after the party pan has been
Precautionary measures when using the party pan
The party pan has a non-stick coating. Therefore
take note of the following:
• Do not use sharp metal objects (if you wish to cut
meat that has been cooked in the pan, first re-
move it from the pan and cut it on a board/plate).
• Do not use a knife to cut meat in the pan.
• Do not put the thermostat on the party pan, it
should never come in contact with the pan.
• Do not use detergent, or a nylon or metal brush.
They will damage the non-stick coating of the
pan.
contact your supplier
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
4. To switch off or remove the thermostat, turn the-
knob to "Off".
NOTICE: Ensure that you connect the thermostat in
the appropriate manner. When removing the ther-
mostat, never pull the lead but grip the plug itself
to remove it.
• A hissing sound heard when using the pan does
not indicate a fault. This noise originates from the
heating element and the party pan.
• Do not touch hot dishes with your hands, do not
put flammable objects on the pan.
used. Therefore, first allow the party pan to cool
down before removing the thermostat!
3. After allowing the pan to cool down, cover the ther-
mostat socket to prevent water entering it during
cleaning. Clean the party pan with a soft sponge.
Then wipe the device with a dry and soft cloth.
• The pan must be cleaned with a wet cloth after
use. Fat remaining on the surface can cause a
fire.
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects.
Do not use petrol or solvents! Clean with a damp
cloth and detergent if necessary. Do not use
abrasive materials.
EN
5