Risk of damage
Notice
Risk of damage to property!
If the cooling unit has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
• If possible, only transport the appli-
ance in a vertical position.
• Allow the refrigerator to stand up-
right for two hours before start-up.
The lubricant will flow back into the
compressor during this time.
Improper handling of the appliance
can lead to damage to property.
• Do not pull or lift the appliance by
its doors or door handles.
• Place the appliance only on a level
and firm surface that can support
the weight of the appliance when
it is filled.
• Do not use sharp or pointed objects
to unpack it.
• When unpacking the appliance,
never damage the insulation ma-
terial on the back of the appliance.
• Do not use mechanical devices or
other means to accelerate the de-
frosting process, other than those
recommended by the manufacturer.
HGS14355EW, HGS14355ES
HGS14355EW, HGS14355ES
• When cleaning, please note:
–Never use harsh, granular, soda,
acid, solvent-based or abrasive
cleaners. These attack the plas-
tic surfaces. All-purpose clean-
ers with a neutral pH are recom-
mended.
–Door seals and plastic parts are
sensitive to oil and grease. Re-
move contaminants as quickly
as possible.
–Use only soft cloths for cleaning.
• Wait 5 minutes after switching off.
Only then switch the appliance on
again.
• Only use original accessories.
Safety
Safety
EN-9
EN-9