Control Elements; Mounting The Iu0U Automatic Charger; Mounting Instructions - Waeco PerfectCharge IU1012 Bedienungsanleitung

_910-012PFC.book Seite 22 Mittwoch, 21. Juni 2006 4:12 16
PerfectCharge IU1012
5.1
in 1, page 3
6
6.1
If you wish to mount the IU0U automatic charger in a fixed position, please
observe the following mounting instructions:
Downloaded from www.Manualslib.com

Control elements

Item
Explanation
1
Main switch
2
Mains connection
3
Cable with battery connection terminals
4
Fuse
5
Air outlet
6
Status LED

Mounting the IU0U automatic charger

Mounting instructions

You can mount the IU0U automatic charger either horizontally or vertically.
Do not mount the IU0U automatic charger
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, closed spaces. The minimum
clearance around the IU0U automatic charger must be at least 25 cm (2,
page 3).
The air intake on the underside and the air outlet on the rear of the IU0U
automatic charger must be kept clear.
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the IU0U automatic
charger under load can lead to the automatic shut-down.
The installation surface must be level and sufficiently sturdy.
manuals search engine
Mounting the IU0U automatic charger
22