First Time Start-Up Operation - Teuco 629 Betriebsanleitung

EN
INSTRUCTIONS FOR USE
STARTING UP FIRST TIME
1 - REMOVE THE COVER FROM THE MINIPOOL
remove the cover by unhooking the straps .
2 - FILLING THE MINIPOOL
Fill the minipool until the skimmer lifts up .
The water filling the tub must not exceed 35°C .
3 - SWITCH ON THE ELECTRICAL SYSTEM
ATTENTION: Switch on the electrical system AFTER
having filled the minipool with water.
The main selector switch that was installed during the installa-
tion phase of the minipool must be turned to the "ON" position .
Check that the circuit breaker switch installed during the
pre-installation operates correctly by pressing the test but-
ton which should intervene on the circuit .
reset the switch after testing it .
The recirculation pump automatically switches on .
Switch on the hydromassage unit by pressing the "pump"
key on the control panel .
Open all the jets and check that there is no water leaking
from the hydraulic connections and that everything is
working correctly and then switch off the pump .
If the writing "H2O" appears on the display, the
hydromassage pump has not switched on.
Add water to the minipool until the writing "h2O"
disappears from the display and the unit can then be
switched on .
Attention: Sometimes the unit does not switch
on if air has accumulated in it. To release the air
from the system, slacken the ring of the pump
until the hydromassage or the recirculation
system switches on, then retighten the ring.
629
21