HP Pro Laminator 600 A4 Bedienungsanleitung Seite 19

If the laminator was previously used in "Hot laminating" mode, the
The laminator must be allowed to cool down for approx. 30 minutes before it is ready to
operate.
Î Cold laminating: The selected button lights up BLUE
Î The laminator is ready for operation.
Caution!
Risk of burns through hot machine surface!
The laminator heats up during hot lamination. Do not touch the device surface during
operation.
2 Place the material to be laminated inside the laminating pouch. For the best results, leave a
space of 3 mm to 5 mm at the margin on all sides.
3 Insert the laminating pouch in the infeed (rear) of the laminator when ready to operate.
Î The laminating pouch is drawn in and discharged on the output side (front) of the lamina-
tor.
Caution!
Risk of burns through hot laminating pouch.
When the laminating pouch is ejected after lamination, it is extremely hot. Only remove
the ejected lamination pouch holding it at the cooled end.
4 Remove the laminating pouch from the laminator.
5 Press the button (9) to switch the laminator off.
Î The lamination process has been completed.
If you no longer need to use the laminator, switch the power switch (4) to OFF.
Caution!
Risk of burns through hot machine surface!
Wait a few minutes after switching off until the laminator has cooled down before you
touch it.
A3 A4 A5 A6 A6 A5
- 19 -
button (7) flashes BLUE.
A4 A3
75MIC
125MIC
80MIC
CAUTION HOT
EN